Loading...

MICRO MACHINING 17-4PH NC PROGRAM 1/32"DIA END MILL

579 views

Loading...

Loading...

Rating is available when the video has been rented.
This feature is not available right now. Please try again later.
Published on Aug 19, 2013

Micro machining with 1/32", 1/16" and 1/8" drills and end mills into 17-4 PH H900 material; work-in-progress is turning center horizontal lathe then vertical machining center.

PO is for a 10 piece lot at $400 per part; use an open machining center; short lead time (ASAP); skilled machinist setup and operate initial release program. Quote $320 but invoice $400 for nc programming off-site and support for a skilled machinist (not a button pusher).

The capability is in the tooling, tool holders and work holding and the machinists setup skills. Hint: Brookfield "V-HOLDERS" and pin gauges for T.I.R.

Some do, some teach, and some talk. Trust, but verify. It's about the money.

www.mfgaa.com
716-652-4510

  • Category

  • Song

  • Artist

    • Big Drum Hit
  • Album

    • Big Drum Hit
  • Licensed to YouTube by

    • The Orchard Music (on behalf of Life Music); Songtrust, ASCAP, and 16 Music Rights Societies
Comments are disabled for this video.
When autoplay is enabled, a suggested video will automatically play next.

Up next


to add this to Watch Later

Add to

Loading playlists...