 All right, Lady, what is this? Hey, I just put together a prototype for my QT2040 Trinky. So this is a Raspberry Pi RP2040 with eight megabytes of flash. There's crystal, a little neopixel, and then two side buttons. This is the reset button, and this is the boot button. And then at the end, there's a STEMI QT connector, and this is STEMI QT-sized, right? It's like the same size only sensors. So I have this over here plugged into my computer as a little demo, and then on my computer, it's showing that, yeah, it's reading from the BME 680. And then I did the QT trick that Pymarini came up with, where the boot button is also a user button. So when I press this, you can see the red LED turns on. And the idea is that with a little bit of mechanical assistance, a couple of plastic standoffs, you would have this mount together as one little piece. It's a very handy sensor input for any computer with USB-C.