Loading...

Busker 18

1,810 views

Loading...

Loading...

Loading...

Rating is available when the video has been rented.
This feature is not available right now. Please try again later.
Published on Sep 6, 2011

Clip number 18 consists of a slide show covering the steps I went through to make the crank handle. Cutting the crank from a piece of hardwood, selecting the hardware for solid assembly and cutting the thread on the end of the crank shaft. The crank is 6mm with a .1 thread. My engineer neighbour told me that the best lubricant when using taps and dies is Lard - I followed his advice and it worked well. There is no commentary here 'a picture for a thousand words'. Part nineteen will cover testing with pressure guage, pipe assembly and tuning. Part twenty a short summary of the year project, introduction to the next project and a short concert!

Plans available from www.Johnsmithbusker.co.uk To join the Busker building community become a member of The Busker Forum hosted by Melvyn Wright

Loading...

When autoplay is enabled, a suggested video will automatically play next.

Up next


to add this to Watch Later

Add to

Loading playlists...