How to replace a Moen faucet cartridge - Moen Faucet Repair





The interactive transcript could not be loaded.



Rating is available when the video has been rented.
This feature is not available right now. Please try again later.
Published on Mar 31, 2012

Subscribe and visit our weekly podcast for more tips https://itunes.apple.com/us/podcast/f...
I cover the steps on how to replace a Moen faucet cartridge on a single handle kitchen faucet. The steps are the same for a bath sink, tub or shower faucet with the same Moen cartridge.

The most popular Moen cartridge is the 1200 brass style or the 1225 plastic body. You can replace an old cartridge with either model. Another style cartridge from Moen is the PosiTemp. It is also for single handle faucets but has a built in anti-scald feature. It will not fit in the faucets that take a 1200 or 1225 style, so make sure to look at your old cartridge.

You will need some of the following tools to replace a Moen faucet cartridge: adjustable wrench, channel-lock pliers, open-ended wrench, flashlight, and screwdrivers.

Some kitchen faucets will have a series of pieces that need to be removed to get to the cartridge. They can include the handle, handle assembly, retainer ring, pivot nut, and spacers. It is a good practice to lay out each piece in the order you removed it, so reassembly is easier.

Some faucets may also have a retaining nut that needs to be unscrewed to get to the cartridge.

Once the handle is removed and the parts under the handle are removed, you will need to take out the retainer clip. This is a "U" shaped clip that holds the cartridge in place.

In most of the packaging of a new Moen cartridge is a small white plastic tool to help replace the old cartridge. Place the removal tool onto the old cartridge and seat it between the two ears that stick up on cartridge. Use pliers or a wrench to twist the tool and loosen the old cartridge.

Remove the plastic tool and grab the cartridge stem and pull it out of the valve.
To install the new cartridge, pull the stem out so it is in the open position. This makes it easier to push into the valve. Grease up the o-rings with plumbers grease. In old faucets, the buildup of minerals and rust can cut an o-ring if it is not greased up. This will also help add life to the o-rings. Plumber's Grease is a silicone based grease that will lubricate and protect rubber parts. It also helps keep cartridges and valve stems from corroding. Vaseline and other petroleum based products are not recommended for any rubber parts. Petroleum based lubricants will swell and soften rubber parts and o-rings.

You need to align the ears sticking up on the new cartridge with the slot for the retainer clip. The clip needs to go around the ears to hold them in place. Replace the retainer clip.

Now replace all the parts that were removed and test the faucet.

If the hot and cold are reversed when you use the handle, only remove the handle and spin the stem 180 degrees. Do not remove the clip or cartridge, just spin the stem.


When autoplay is enabled, a suggested video will automatically play next.

Up next

to add this to Watch Later

Add to

Loading playlists...