Rating is available when the video has been rented.
This feature is not available right now. Please try again later.
Published on Apr 6, 2012
Insert a CombiSwitch and change its CMD to ON, its SEND WHEN to ON. Copy this sprite 3 times and then change DATA3 of CombiSwitch two and four (as seen from the right) to 6.
Now give the 1st digit (the one at the right) RX ID of 100 and a TX ID of 101, the 2nd digit RX ID 101 and TX ID 102, the 3rd RX ID 102 and TX ID 103 and the 4th (at the left) RX ID 103.
Finally, draw a sector outside the room the clock is in and set RX ID to 7 and TX ID to 100, set its CMD to ON and check boxes SEND AT ON and SEND AT OFF and the boxes of both WAITTIMES and set the time to 10.
You can extend the clock with a fifth digit simply by inserting another CombiSwitch that receives on the same channel as digit four is sending. And so on.