Upload

Loading...

MOV0ab

37 views

Loading...

Loading...

Transcript

The interactive transcript could not be loaded.

Loading...

Loading...

Rating is available when the video has been rented.
This feature is not available right now. Please try again later.
Uploaded on Dec 16, 2010

Single Phase Operation: Top coil is energized; remaining components removed and given shorted loops, making for two air core secondaries, where the third coil shares its induced currents with the fourth extra coil resonance, obtained by having its cylindrical capacity enclosed by the fourth coil itself that uses a flat plate capacity to resonate. With only a single phase attached we have at 6:34 a 2.4 volt source/(14.8 volts with all three interphasal voltages open without loads) enabling at 6:35 a 7.1 ma current. Adding an identical resonant secondary underneath that coil by shorting out the disconnected loop now we find at 7:44 the voltage source has increased from 2.4 volts to 11.3 volts, but now it's primary amperage has fallen to 2 ma, shown at 7:50, but its identically resonant coil secondary underneath receiving all influence through the air shows 8.6 ma at 7:55 in the video. Adding even further higher induction coils in resonance underneath and aside each other we find that the source has changed to a 9 volt level enabling 3.2 ma, its bottom secondary receiving 6 ma, and the two extra coils having 7 times more resistance both aquiring .67 ma, all of this with only the top coil energized

Loading...

When autoplay is enabled, a suggested video will automatically play next.

Up next


to add this to Watch Later

Add to

Loading playlists...