 Hi guys, I'm Christian over at the Purefix garage. Today, I'm going to show you how to install a new set of pedals on your bike When you get new pedals, there's a right and a left one These pedals are marked or stamped on the spindle and it's very very important Believe it or not a common mistake that a lot of people make is installing their pedals backwards But you're not going to make this mistake because you're watching this video, right? It's got an R and an L on it. For this job. We're going to need some grease. This is necessary So make sure you get some. We're also going to need a pedal wrench for this install First put a little bit of grease on each pedal thread like so Go ahead and rub it in your fingers. We're working on a bike here. So don't be worried about getting dirty Here's a little trick for you when you're installing pedals when you put the right and left pedal on the correct side Pedal backwards and they'll self-thread themselves in. It's just that easy Once they're tightened in with your fingers go ahead and grab your pedal wrench to give them the final torque Go ahead and tighten them down firmly Boom job. Well done. It's very important before you thread these in all the way to make sure the pedal orientation is correct There's a right pedal and a left pedal for a reason if you don't put those in correctly You will damage part of your bike if you have any questions about the job completed in this video Drop us a comment below or hit us up on social media Thanks for checking out another episode of purefix garage Make sure to subscribe to our other videos to keep your bike in tip-top shape keep the rubber side down and I'll see you next time