 In this video I'll be showing you how to art resin an outdoor bar top and we even embedded a coin in one of the cracks in the wood. So here's a fun little project that I'm doing with my neighbor. He's building an outdoor bar slash shed. So his bar top is going to be made out of this nice wood. I think it's cedar and we are covering it in art resin. Now art resin is great for bar tops. It gets nice and hard and we did a first coat over the whole thing. Not using too much resin just because on your first coat with wood lots of times it will just get soaked right in and you'll lose a lot of the resin. So we have it lifted up on just baby's blocks so that the drips can fall off. Just pour it over the whole thing, bread it out, rub the sides with some gloves and then rub off the bottom drips, then let it sit over neck. Here I am day two. It's cured, it's hard, it's not sticky anymore. We did our first coat and the point of the first coat was to fill up the craters so that we can embed this Canadian Looney in about halfway. So we filled that up with resin. It will get at its hardest after about three days. What I'm going to do now is I'm going to fill up these cracks so that every single crack and dent is totally flushed with this surface and that's the second coat. I'm going to wait till that dries and I'm going to sand the whole thing down with a power sander just to give our final coat something to grip onto and to make sure that everything's nice and level. So this final coat will have just a flat surface to be applied onto. So once again I'll set it up. I'll clean it off all the dust. It looks really scratchy but don't worry when you pour over top that all goes away. Again just mix up equal parts. This is about seven square feet. This 32 ounce kit does eight square feet. I'm just going to use a bit less than full containers of the 32 ounce starter kit to do this bar top. Pour it over the whole thing, push it around, wipe the edges and then take a torch, get rid of all the bubbles. Use our pre-made boxes to cover it from dust and again let it sit overnight and then we'll be done. That's it. Install it and have a beer.