Loading...

the Ricks Beading loom

43,221 views

Loading...

Loading...

Transcript

The interactive transcript could not be loaded.

Loading...

Loading...

Rating is available when the video has been rented.
This feature is not available right now. Please try again later.
Published on May 29, 2012

Never have more than two warp threads!

the Ricks Beading loom is a patent protected BEADSMITH exclusive item. Use any size bead and even mix bead sizes easily! With a comprehensive users guide, adjustable length, quality construction and, ergonomic design this loom will quickly become popular item.


From Paul Ricks- Inventor of the BEAD LOOM-

I have made a wider loom in the past, but discontinued it because (a) it was a slow seller and (b) about 9 inches wide is the widest practical width for this method of looming.

If you go wider than about 4", you must use a much heavier gauge music rod for the warp rods to give them enough strength to resist bowing. This means the rods will have a larger diameter and that would produce an unacceptably large loop in the ends of the warp threads resulting in a "loose" finished project. For the 9" wide loom I produced I used .075 music rod and that was OK. Anything larger is unacceptable.

I have had a few people request looms of greater width and I recommend to them that they make their project in 3" wide strips and square stitch the strips together to make their wider projects.


I hope this answers your question ........
Paul

Loading...

When autoplay is enabled, a suggested video will automatically play next.

Up next


to add this to Watch Later

Add to

Loading playlists...