 Uly knot slider charge. Use a sharp knife to cut 3 1 inch by 5 inch strips of rubber. Cut one 8 foot piece of 50 grain per foot debt cord. Note, testing has found that 96 inches of debt cord will cover most standard and non-standard doors. Cut 12 inch pieces of debt cord. Cut the remaining debt cord into three equal length pieces. Ensure that each piece is 24 inches long. Use electrical tape or tape to secure four 5 inch pieces of debt cord onto one side of a 1 inch by 5 inch strip of rubber. Ensure that an untapped area is left on the top center of the debt cord where the Uly knot will lay. Repeat this step for the other two pieces of rubber. Use the 24 inch pieces of debt cord to tie three Uly knots onto the 8 foot piece of debt cord. Ensure that the Uly knot slide freely on the 8 foot section of debt cord. Use tape to secure the Uly knots to the rubber pieces. Cut three 1 inch by 5 inch pieces of double sided tape and attach them to the bottom of the three charge bodies. Use buddy tabs to ensure easy removal of the tape backing. Tie an overhand knot and one end of the 8 foot piece of debt cord to prevent the charge bodies from sliding off. Fold 12 inches of the other end of the 8 foot length of debt cord upon itself and tape it to make a 6 inch priming pigtail.