Loading...

=wc= how to RC Helicopter setup made easy all helicopter head unit set up pitch and expo

17,681 views

Loading...

Loading...

Transcript

The interactive transcript could not be loaded.

Loading...

Loading...

Rating is available when the video has been rented.
This feature is not available right now. Please try again later.
Published on Aug 16, 2012

if am wrong or if there is anything you dont understand pz ask we would love to help you.
step 1 unplug 2 wires from your esc to motor
step 2 switch to idleup ninety your servo arm make sure its level
step 3 unsnap 2 links from the front of the swash plate push the swash plate up until the mixing arms are level then adjust the 2 linkages you took off til they reach the swash plate.
step 4 with a swash plate leveler take the head off move the throttle up and down make sure the swash is level use the ball links to adjust the height dont use sub trim for this
step 5 using a pitch gauge adjust the 2 long linkages until your main blades are at zero pitch
step 6 check your pitch.

OR YOU CAN DO LIKE MY BUDDY JOHN RECOMMENDED BELOW
Try not to use sub trim move the servo arms around to get as close to 90 even try new arms if you can same as the tail. Go with the factory link numbers to get you in the ball park and shorten your links to even it up. If you still have a flybar go with one piece links where ever possible.

Loading...

to add this to Watch Later

Add to

Loading playlists...