Loading...

10mm Bullet Swaging Part 2

23,359 views

Loading...

Loading...

Transcript

The interactive transcript could not be loaded.

Loading...

Loading...

Rating is available when the video has been rented.
This feature is not available right now. Please try again later.
Published on Oct 30, 2010

This is an advanced video series on how to take 3/8" brass tubing and turn them into a 40/10mm jacketed hollow point. It's a very easy process although it can take up to 12 steps depending on what you want to accomplish. The dies are from C&H 4D and with a few other tools that are around the bench you can make super high quality bullets from 130grs up to 240grs with a partition using a 35 caliber gas check between two cores.

The equipment you need is a set of CH4D 40 caliber dies the model 101 series and you will need the 9mm swaging punch to make a recessed core inside the jacket. Use a good reloading press that is made of steel. You will need a Harbor Freight mini chop saw and get some extra blades. To ease cutting use wax to rub on the blade about every 5th-6th cut.

-The dies are available at:

http://www.ch4d.com/

Or call them at: 1 (740) 397-7214

Loading...

When autoplay is enabled, a suggested video will automatically play next.

Up next


to add this to Watch Later

Add to

Loading playlists...