 You can 3D-print your own case for the Adafruit Micro-Lipo Charger. This features Fival input for charging single lithium-ion or lithium polymer batteries, and it ships with a free JST cable. The new V2 features a built-in slide switch so you can easily switch between the two charging rates. The PCB has pads for USB, so you can plug it directly into anything with USB type A. It features charging status LEDs so you know when your battery is fully charged. This supports all of the Adafruit Lipo batteries so you can safely swap between the different types. For all of the technical details, be sure to check out the product learn guide. 3D-print the two halves in your favorite filament. You can use translucent PLA to make it look like those clear enclosures from the 90s. The PCB sits over the bottom half, and the top snap fits over the sides. The case features a cutout for the built-in slide switch so you can still access the charging rate. The JST connectors are covered to help keep out any dust to provide a bit of protection. We hope you enjoyed the new Adafruit Micro-Lipo Charger and 3D-print the case for your next project.