Loading...

Arduino 101 - Overview Class taught by Schuyler St. Leger

7,447 views

Loading...

Loading...

Transcript

The interactive transcript could not be loaded.

Loading...

Loading...

Rating is available when the video has been rented.
This feature is not available right now. Please try again later.
Published on Nov 19, 2012

This 60 minute course covers the basics of Arduino. It spans from an overview of the board design (components, I/O, power, etc.) to the software development environment. Schuyler St. Leger (a.k.a. @DocProfSky), the instructor, then goes through several live examples of prototyping circuits using an Adruino Uno and a breadboard along with additional components.

Programming and circuit examples include:
1) Blinking the on-board LED.
2) Blinking an LED via the digital header I/O.
3) Adding a button switch into the circuit to control the LED's on/off/on modes. This circuit expansion introduces a breadboard and the concept of a pull-down resistor to suppress electrical noise.
4) Using a potentiometer to control an LED's blink rate. The inner workings of a potentiometer is also explained.
5) Using a potentiometer to control an LED's brightness using Pulse Width Modulation (PWM.) The concept of PWM is also explained.
6) Controlling a servo motor.
7) Using a potentiometer to control a servo motor.


This course was recorded in front of a live audience at Desert Code Camp, November 2012 at Chandler-Gilbert Community College in Chandler, AZ.

Loading...

When autoplay is enabled, a suggested video will automatically play next.

Up next


to add this to Watch Later

Add to

Loading playlists...