 Hey everyone, Drew with GeoArm and I am back to talk to you about accessing the arming settings for both staying and leaving on your GeoAlarm control panel. Go ahead and hit the hamburger icon and then into your master code. Okay you want to hit the arming button here and that is where both of your modes exist staying and leaving so if you want to look at your staying options everything's there. It tells you what it is. Bypass arm is is enabled. Voice enunciation is enabled. The beep countdown is enabled. The exit delay is down to zero seconds because typically in staying mode you don't want that enabled. The arm sensor, it'll show you the sensors that are going to be arming within that group. Arm with the pass code, it wants to know if it's going to be required to enter the code in order for that arming to occur and also disarm passcode. Those are toggle options. Okay now we'll go ahead and we'll go back and then we'll go back into the leaving menu. Okay and there's a few more, actually a few less in there with this menu than the other one but as you can see the exit delay is enabled everything else is on there and the toggles you know obviously for arm with the pass code. The only thing that's not here is the disarm with passcode. It's going to require the passcode every time. Go ahead and hit the back arrow and that is how you access the arming settings within your geolarm control panel. If you guys have any questions or comments please leave them below. Take care and have a great day. Please like and subscribe to our page for helpful programming and installation videos, product reviews, monitoring, products, and more. Visit www.geoarm.com or call 877-443-6276 that's www.geoarm.com or 877-443-6276 geoarm the worldwide leader in DIY security. you