Hero Bow Mark 2





Rating is available when the video has been rented.
This feature is not available right now. Please try again later.
Published on May 21, 2010

2nd part of the video has me shooting at a 10 inch diameter pot from 30ft away. The last hit glanced off the pot and flew off to the side.

Made almost exclusively of PVC, this bow sports an 8 round clip. The clips are completely detachable and hold Nerf® Taggers, Whistlers or Buzzbee's®. The bow, 1/2" SCH40 reinforced by 3 fiberglass rods, pushes an O-ring sealed piston through a 1.5" SCH40 cylinder. The resulting high pressure air moves through a 45 degree elbow into a Wye joint and out of the barrel (1/2" SCH40). Furthermore, the bow itself can be detached from the pneumatics for portability or storage.

Improvements over Mk 1:
2.25x air volume by going from 1" to 1.5"
PI*r^2 = circular cross section.
.75"^2 = .5"^2*x
0.5625 = .25*x
2.25 = x

Better flow with 45 degree elbow and Wye joint

Much heavier draw weight with shorter bow and 3 fiberglass rods

less pieces, ergo more durability

smaller size and completely detachable bow for portability

Vastly improved piston with better O-ring sealing.


When autoplay is enabled, a suggested video will automatically play next.

Up next

to add this to Watch Later

Add to

Loading playlists...