 Place the factory springs with these bad boys right here. Remove the glass bed. I'm going to start with the front and just loosen them together until they completely come off. And do the same in the back. Once you have the wheels taken off, lift up your build surface here. And we're going to set it aside like this. So grab the old flimsy springs here and take them off. Then you want to take your new springs like this right over the holes. The back one, you'll have to put that on first. Then put your strain relief on like that and the screw will go down through it. Set it down on top of those springs. Make sure you get the springs underneath. To put the wheels back on, you want to do them in pairs. And they're going to spin towards you to put them back on. Start the back ones. Do not tighten these yet. You want to get the back ones on first. Now that you have them all tightened all the way down, put your glass bed back on. Don't forget you have to re-level the bed. You're going to love these new yellow springs.