Upload

Loading...

Proper break in of Harbor Freight central pneumatic 29 gallon 2hp 150psi air compressor model 68127

34,241 views

Loading...

Loading...

Transcript

The interactive transcript could not be loaded.

Loading...

Loading...

Rating is available when the video has been rented.
This feature is not available right now. Please try again later.
Uploaded on Jan 17, 2012

Well, santa was good to me this year. This is my new harbor freight central pneumatic air compressor. This is what the manual concludes as proper break in procedures, you are supposed to check the compressor head bolts before initial run and after the 10 minute no load pump break in and again every 500 hours. They are supposed to be torqued at 27nm (just about 20ft lb.). I always change the oil in chinese equipment even before the first start up because I don't like their quality of oil and there is usually some metal remnants in the oil if they test run at the factory and just leftover from casting parts. I then put in good quality oil, run it once or twice and change it again to make sure I get all the metal particles out of the case. I shot this over a few days because my health condition really really really limits me for doing anything longer than 15 (or less) minutes at a time. Hopefully that will change very soon. As you can see I got this at christmas and I just got done shooting and uploading video. This looks to be a decent compressor, but won't really be able to test it out until after my surgery and recovery, which won't be till about march at the earliest. I don't work for harbor freight nor central pneumatic, just following the manual and my own take on some things. I've had great success with some chinese manufactured tools and equipment, and I've had some great disasters as well. It's best to look at the item you are considering in the store, and do lots of online extensive research before a major purchase. If you plan on using the item heavily or every day, I would buy a used name brand tool thats easy to get parts for or fab parts for before I bought a chinese one. This will see use about once a week or even longer intervals, so it should be ok. Also, I would not buy ANY chinese oil less compressor for two reasons, they wake the dead and they typically fail apart within the first few uses if not shorter. This is a Central Pneumatic ( Distributed by Harbor Freight ) 2hp 150psi 29 gallon 115v single phase two piston pump single stage vertial air compressor part number 68127 I will also upload a second video very shorty showing tank fill time from 0 psi to full 150 psi I wish this model had pneumatic tires, would make moving it around much easier, I may have to adapt it to use a set in the future.

Loading...

Advertisement
When autoplay is enabled, a suggested video will automatically play next.

Up next


to add this to Watch Later

Add to

Loading playlists...