 WaterWare is a cover for the Samba audio processor that provides complete water protection. It consists of a skin and an adhesive seal tape. You can use each skin up to three times, but the adhesive seal tape needs to be replaced after each use. Only use alkaline or silver oxide batteries with WaterWare. Make sure your hands are clean and dry before handling WaterWare. Check WaterWare for damage and make sure the inside is clean and dry. Discard WaterWare if it has any damage. Remove any attachment clip from your Samba. Hold your Samba with the flat side facing up so that you can see the metal logo. Now start inserting Samba into the skin of WaterWare by placing the side opposite the battery compartment into the pocket with the circular flap. Hold Samba between two fingers and grab the rectangular shaped flap with your other hand. Pull WaterWare over the entire processor. It will form a tight fit, so some tension with WaterWare should be expected. The overlap should be evenly distributed around the edge. For a watertight closure, it is essential that no wrinkles form on the flaps or edges of WaterWare. Avoid pulling on the additional fixation option on top of WaterWare. You can easily recognize it by its fixation hole. The adhesive seal tapes are used to cover the opening of the skin. Make sure that all components are clean and dry before you attach the adhesive seal tape. Remove the adhesive seal tape from the protective cardboard. Start applying the tape on the side where the battery compartment is. Make sure that both flaps of WaterWare remain flat on the surface of Samba and no wrinkles form during the application of the adhesive seal tape. Also, ensure that the tape fully covers the rim of the WaterWare skin opening and is not offset or misaligned. Firmly press down along the adhesive section to make sure that WaterWare adheres completely. To provide protection against water, the adhesive seal tape must completely adhere to all edges of WaterWare. Make sure that WaterWare was not damaged during the application. To avoid losing the processor during activities, you should use additional fixation such as the metal sports headband, a swimming cap, or an attachment clip. To tie an attachment clip to WaterWare, use the semicircular flap on top. Pull the loop of the string through the hole of the semicircular flap and pull the end with the attachment clip through the loop. Your Samba with WaterWare is now ready to use. Position Samba with WaterWare over the implant. Fix the audio processor with the attachment clip and enjoy your water activities. To remove WaterWare from Samba, first remove the attachment clip and then carefully remove and discard the adhesive seal tape from WaterWare. Use the rectangular flap of the skin to gently pull WaterWare off of Samba. Make sure that you do not damage WaterWare. The skin of WaterWare can be used up to three times, but the adhesive seal tape needs to be replaced each time. Follow the previous instructions and ensure that the adhesive seal tape seals properly and that the WaterWare skin is not damaged before reusing.