DPMS-CMMG AR-15 Tactical Carbine





Rating is available when the video has been rented.
This feature is not available right now. Please try again later.
Uploaded on Jan 29, 2011

Home assembled AR-15 from mail order sources...

DPMS lower
CMMG 14.5" Government profile upper, mid-length gas system, micro block
pinned/welded Yankee Hill Phantom Flash Hider
Timney Target Trigger
Magpul UBR Buttstock
Magpul MOE Handgrip
Magpul MOE Triggerguard
Troy Industries 13.8" MRF RX Tactical Rail
Eotech A65.1 Holographic Sight
DPMS Front and Rear (co-witness) Rail Sights
Magpul AFG2 Angled Fore Grip
Magpul XT Rail Covers
Inexpensive no-name flashlight mount
Fenix LD25 1 inch flashlight
Magpul Windowed AR-15 30 round magazines
Magpul Single Point Sling (not shown)

I installed/assembled everything. The Troy Rail was a bit of an adventure. I had to cut off the ring and omega spring assembly with a dremel tool due to the welded on flash hider. That wasn't too bad, kind of bead blasted part of the upper finish inadvertently with the powderized aluminum spray - scratched the receiver also when the dremel slipped as well... but it was the front handguard retainer that was the unexpected pain in the ass, it was practically welded on, it would not BUDGE ... ended up cutting it off with the dremel also!

Heavy gun @ 9.5 pounds as you see it in this vid, but exactly what I set out to build - a short, accurate tactical carbine for use in real world WROL defense, like after a natural disaster - not a lightweight fantasy end of the world wander the wasteland post-apocalypse gun. I have a lighter AR-15 as well, in case I do have to wander the post-apocalyptic wasteland! LOL :) I'll do a vid review of it later, doing some upgrades to it right now - its in pieces!


When autoplay is enabled, a suggested video will automatically play next.

Up next

to add this to Watch Later

Add to

Loading playlists...