 Hey guys, this is Kevin. This is part two of the story. If you haven't seen the part one, I put the link above. My customer contact Epson for warranty and Epson said, how about you keep the printer and I give you $120 and Yeah, that sounds good deal. So the customer come back for me to fix it It's an easy fix because the clock is inside the tube. I forgot to turn the camera on. I'm sorry I already cleaned the tubes I disconnect the tubes from the printhead and then disconnect the other side here Just pull it out. If you need a new set of tubes You can just go to bch technologies.com and go to printer parts Epson and eco tank tubes cleaning tubes is not that hard. Just take the tube off soak in warm water give a little massage and suck really hard from the one end and then push then suck to try it make sure that those levers open and take one end and start sucking and It should come in really smoothly like this Again, where get that needle? Okay, go back to bch technology.com and go to accessories and syringe and needles and It's this four-piece plastic refill needle tip after we check each tube make sure they Connected to the printer and then can suck in smoothly. We connect them back to the damper Now we need to prime the damper. We take a 10 mil syringe and Resurblade just cut off a little piece from the top put your hands in the back of the damper and Just pry that tab backwards and now you can remove the damper you can see there's lots of air in the damper and Now that's why we need a primate Hold the damper this way and insert a syringe and start sucking the ink should come into the damper very easily and Suck until you get a ink inside at the syringe It's easier to show you show you in a lighter color like a yellow Now I can put everything back and try it Now the printer can print good pictures continuously. I remember the old problem was the printer get a suffocate after the first page Okay, I hope you enjoyed this video visit us at www.bch Technologies.com or locally at Greensboro, North Carolina. Cheers