 Hey everyone, Drew with GeoArm and I am back to talk to you about the Sensor Settings menu and just how you get there and access it. Alright, go ahead and hit the hamburger icon, okay, you hit Devices, you go to the specific group, the device exists within, in my case it's Doors, and then I'll choose my garage door here. This is the menu for your sensors, for your specific sensor here, and it will have the different options, as you can see, the name there, the alias, whether you want the voice enunciation on, whether or not you want the chime to be enabled, the sensors type, the signal of the device, which is a very useful tool when you're putting your sensors in place, so make sure you check that, the serial number of the device, and whether or not you want to delete it there. And also, don't forget about the toggle option to make it active or inactive. Say the device has a low battery and it's just annoying you, you want to make it to where it's not bothersome anymore, you can just go ahead and disable that temporarily until you replace the battery, then when you're ready to, you can flip that switch again. Alright, ladies and gentlemen, that is a brief rundown of the Sensor Settings menu within the GeoArm Control Panel. If you guys have any questions or comments, please leave them below. Take care and have a great day. Please like and subscribe to our page for helpful programming and installation videos, product reviews, monitoring, products, and more. Visit www.gourm.com or call 877-443-6276, that's www.geoarrm.com or 877-443-6276, GeoArm. The worldwide leader in DIY security.