 Now we will create the project for Kale and for Kale we here select the mdk arm Ration 5. I am using the last one. I click on the ok and we regenerate the project for the Kale. When everything is ok and our coil is installed the QPMix allow us to open directly the project then I click on the open project and Michael will be open few minutes seconds. Now we have opened our Kale project. If we want to do the same change as inside the IR lab we need here open the GPIO1 Kale project. This is my name the user section of the application then the main main.c and here like before we here need to put two parts one is to toggle with the GPIO then it will be HL. The name of the payfair it's here the GPIO underscore and I know that I need to put the toggle pin if you want that the Kale will help you use the control plus space. The toggle pin like before I know that the pin is the GPIO A and it's the GPIO underscore pin underscore the number is 5. I know that on my nuclear board is on the GPIO PA5 is the is the LED and this will toggle with my LED and I here put the HL delay and for the 500 milliseconds. Then I will save my code here with the save button or control S I will compile my code with with this button or the control F7 with the F7 and here you can see that Kale compiling my code will take well. Okay if everything is is prepared then here in the project option we can check if we have here selected the debugger if we have the stealing debugger then in the settings you can see that the core is here available then everything seems okay then it's not necessary to change anything and I can hear with this button start debug. The my code is loaded into into the microcontroller is flashed. Now I am in the debug you can see I am on the start of the main and here with this button run I can run my application. If you have your kit you can see that your LED will be blinking like like the mine is. In case that you want to stop the stop the debugging as step your code you press here the stop button with this with this option you can you can step step the code and if you want to go out of the debug then here you press the start stop debugging session and this is everything how to flash your code your very first test code into into the STM32 in Kale.