 Carefully strip approximately 70mm of the outer sheath, ensuring you do not damage the foil. Remove one of the foils. Take the remaining foil and fold in half lengthways, ensuring the shiny surface is on the outside. Wrap the foil completely around the sheath and then wrap the drain wire over the top once. Place the wire manager over the conductors and push down ensuring the drain wire is in one of the slots and rotate it once. Arrange the conductors in the correct colour code. Typically this will be T568B. Whilst the conductors can be placed in the correct slots using just your fingers, a small pair of pliers can save strain over a large number of terminations. Using a pair of flush or side cutters, cut the conductors flush with the side of the wire manager. Place the wire manager onto the IDC's and squeeze together the metal butterfly wings. To ensure the correct alignment, follow the arrows on the outlet and the wire manager. Using a pair of pipe pliers, gently squeeze together the metal butterfly wings to complete the termination. Wrap the remaining drain wire around the metal tab at the rear followed by the tie wrap, cutting off any excess.