Loading...

How to Install and Manage progeCAD NLM Version

3,987 views

Loading...

Loading...

Transcript

The interactive transcript could not be loaded.

Loading...

Loading...

Rating is available when the video has been rented.
This feature is not available right now. Please try again later.
Published on Feb 12, 2015

progeCAD NLM, the Network Version, Installation and Management
progeCAD NLM is a network version, which allows to run concurrently a number of progeCAD copies that corresponds to the number of purchased licenses on various workstations on the network.

The NLM network version consists of two parts:

• The NLM Server software

• progeCAD clients, that can be installed on all the workstations connected to the network.

The maximum number of progeCAD copies in simultaneous use is equal to the number of NLM licenses that you purchased.

1. How to install NLM Server

The NLM Server software manages licenses and assigns them to users who will work with progeCAD.

NLM Server can be installed either on the Server machine or on any workstation attached to the network, where progeCAD Clients will be then installed and registered. NLM Server may coexist on the same machine with the progeCAD Client.

It is recommended to install NLM Server on a computer with Internet access for further registration and licenses activation.

To install NLM Server, run the executable file nlmserver2015proeng.exe on a machine networked to all the workstations where the progeCAD software is going to be used, and follow the instructions.

The Wizard will guide you through the NLM software installation process.

Select the destination folder

Configure the Ports to allow communication between the Clients and Server. Leave the default value for the ports and automatically add an exception to the Firewall.

NLM Server allows to automate the process of Client activation. This is the recommended option.

To complete activation, you must register NLM Server

2. How to Add and Activate progeCAD licenses

Insert serial numbers of the purchased licenses

3. Install progeCAD on all the machines where you are going to use the software.

Follow the instructions of the installation Wizard

4. Register progeCAD

Choose “Register” in the dialog box that pops up at progeCAD Startup.

The serial number of NLM Server is automatically found and assigned to the software. This number is also visible in the upper left corner of the NLM Monitor dialog.

Type Name, Surname and the company name.

Install all the Clients following the same procedure.

Once registered, progeCAD is ready for use. At the program start, the software will make a license request to NLM Server. After availability verification, NLM Server will assign a license and allow to launch the software.

Remember that the number of purchased licenses corresponds to the number of concurrent users

Loading...

When autoplay is enabled, a suggested video will automatically play next.

Up next


to add this to Watch Later

Add to

Loading playlists...