Mazda 3 sway bar install





The interactive transcript could not be loaded.



Rating is available when the video has been rented.
This feature is not available right now. Please try again later.
Published on Feb 2, 2010


Use this video with the proper precautions in place and at your own risk. This video is not certified by Mazda or ASE Certified. I am not ASE certified or responsible for any damage or injury caused by misuse of this informational video.

This is an informational video of how to take off an OEM rear sway bar and replace it with an aftermarket H&R rear sway bar onto a 2007 Mazda 3 "S" 5 door (hatch).

Note: when doing this install, the wheels must be at ride height. So, the vehicle can be raised by a flat alignment style rack, or place the rear of the vehicle on ramps and securely chock the front wheels for safety.

I didn't show it in this video but I torqued the endlink nuts and bushing-bracket bolts to 40 ft. lbs. which are dealer specs.

Thanks for watching!


When autoplay is enabled, a suggested video will automatically play next.

Up next

to add this to Watch Later

Add to

Loading playlists...