 Hey, I'm doing more conversion of testers from using 18C 3.6 to RP2040. This is the PID 5303, which is our ESP32 S2 Feather with BME 280. And I'm uploading the test code over USB. And then the tester output comes here. Test the Pogo. It doesn't actually take 5,000 seconds, because it's been on for a while. But this test is going to be a lot more reliable than using a TCO Raspberry Pi. So I'm really psyched. And it just uses an RP2040 to do USB BitBang host. And then I like that it has analog inputs, unlike a Raspberry Pi, because it can check the voltage of the battery and 5-volt power supply on here. So I'm just going to go through and test these all.