 Hey guys, today I'm going to show you, if you have a CIS for 245-246, I'm going to show you how to replace the cartridge and also how to run the tubes and how to install the clips. I'm going to use those cartridges as an example. They already have holes drilled and washer installed and ready to be installed on your printer. The first thing you'll do is remove this plug and you can throw it away. So for the black it's easy. If you have a black tube, you can just plug it in. For the color, you'll take all the tube off. For each color one, I'm going to give this clip for free. So if you broke your old clip, when you take it off, don't worry about it. One thing you'll do is point those with the letters upwards and slide from the back to the color. You're going to hear a click. And then now we're going to install the magenta or red on the top. And the second one is the sand or blue. You can see it's pretty deep, so when you pull the old one out, you can see you have steel head long elbow, which is easier to have a guide. So you can just put it down. And now the yellow. And now this is the black tube. Now you can put it on top. We go through this loop first. We're going to make a twist. As you imagine, this one goes to the black. And then here is the black cartridge. No matter what you do, the black is always on the bottom. Let me mark it so you can see what I'm saying. So here's to the black. So this is the black tube. This is the black tube. So when you do the final twist, the black tube is on the bottom. So after you do this, you may adjust the length of this tube. The length is from here to the middle of the printer. You should have 24 centimeters. OK, so now we get a tube ready. Now only thing we need to do is to prime it. You will need an empty container. And take out your emergency repair kit, which does include it in the original purchase of the printer with CS. If you don't have it, you can just buy another one. I'll go to bchtechnologies.com and go to Accessories, Primate Click and Strange. And today we cover 243, 245. So this is a short one. In the repair kit, you only get one black clip. You get two paths. Then you have to change the path. For the color one, you are using the shorter slit. So for the color one, I'm going to install this one. And remove this. Tear off the blue tape. And you expose the printhead. Put it on clip. Then you draw upwards. When you draw the ink, you're going to see the ink flowing in. And then when you see the bubble stopped, it is ready to go. So you can just release it. And get a piece of paper towel, dab everything dry. And then now it's ready to install in the printer. For the black, it's the same thing. You remove the clip. And remove the tape. OK. And now we need the black. Put on the pad. Draw ink. You're going to see the ink flowing in from the tube. And then it's ready to go. If one thing is when you draw the black, you don't see any ink coming up. It's because you're using the wrong pad. You're probably using this pad. OK. I hope you enjoyed this video. Visit us at www.bchtechnologies.com or locally at Gwynnsboro, North Carolina. Cheers.