Loading...

How To Install Replace Rear Axle Differential Pinion Seal. BUY QUALITY AUTO PARTS AT 1AAUTO.COM

661,840 views

Loading...

Loading...

Transcript

The interactive transcript could not be loaded.

Loading...

Loading...

Rating is available when the video has been rented.
This feature is not available right now. Please try again later.
Published on Jun 18, 2010

https://www.1aauto.com?utm_source=You...
In this video 1A Auto shows you how to replace the rear axle differential pinion seal. This video applies to the GMC Jimmy model years 83, 84, 85, 86, 87, 88, 89, 90, 91, 92, 93, and 94.

🔨 List of Tools Used in this 1AAuto.com How-To Video:

• Flat Blade Screwdriver
• Pry Bar
• 32mm Socket
• Ratchet
• 7/16 Inch Wrench
• Chisel
• Hammer

🔧 Instructions:

1. Remove bolts from drive shaft 1:10
2. Mark driveshaft 1:58
3. Pull out drive shaft 2:15
4. Clean and mark pinion seal 2:43
5. Remove bolt from pinion 4:00
6. Remove and replace seal 4:18
7. Reassemble 5:30
8. Finish up 7:20

⚠ DISCLAIMER:
While 1A Auto strives to make the information provided in this video as accurate as possible, it makes no claims, promises, or guarantees about the accuracy, completeness or applicability of the content. No information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. All do-it-yourself projects entail some risk. It is the sole responsibility of the viewer to assume this risk. 1A Auto is not responsible or liable for any loss damage (including, but not limited to, actual, consequential, or punitive), liability, claim, or any other injury or cause related to or resulting from any information posted in this video.

Loading...

Advertisement
When autoplay is enabled, a suggested video will automatically play next.

Up next


to add this to Watch Later

Add to

Loading playlists...