Loading...

#36 H2O2 - PWM Case V2 Layout Part 14 of 17

927 views

Loading...

Loading...

Transcript

The interactive transcript could not be loaded.

Loading...

Loading...

Rating is available when the video has been rented.
This feature is not available right now. Please try again later.
Uploaded on Nov 6, 2009

In this episode, finish mounting PCB with hardware and checking PCB for fit, soldering wires to PCB, soldering techniques for wires, hiding wires under PCB.
This is My Concept of what a PWM case should look like. Minimal cooling, no fan! Why, Because The Four MosFets are not driven hard. No moving parts to fail. Automatic Current Control! Why, Because without it any HHO cell will heat up and reach thermal runaway: Current increase and the cell gets hotter this continues until the cell melts or the current source fails or the fuse blows. A Function to monitor Peek Current! Why, because the System will fail if the peek current is to high. Knowing peek current means you are in control of your Cell and its Electrolyte.

Home Page: http://www.youtube.com/user/H2O2FromH20
Web Site: http://www.h2o2fromh2o.oregonsouth.com/
Mosfet Configuration: http://www.h2o2fromh2o.oregonsouth.co...

Loading...

to add this to Watch Later

Add to

Loading playlists...