 Hey guys, Drew with GeoWarm here, and I'm back to talk to you about the 2GIG edge system and how to get it connected to your Wi-Fi network. Super easy to do. Once again, this panel is very, very easy to work with. We're going to go ahead and start off by hitting the gear in the bottom right-hand corner. At that point, you will need to enter your installer code, which on mine is factory, which is 1561. That is the factory code for this, 1561 for installation purposes. What we're going to do is we're going to go to network. We're going to go to wireless. It's going to scan for your access points, so I'm going to go ahead and highlight mine here. At this point, you are going to put in your Wi-Fi password. It will be case sensitive as well, so make sure that you put it in correctly. Then at that point, it will attempt to connect, and it should automatically do that for you. At this point, you are connected to the network. As long as you see this new setup screen, it'll have a little icon that says forget this network in the bottom right. Once you've seen this, it has joined successfully, and you'll go ahead and press the back arrow all the way out of programming. Make sure to subscribe to our YouTube page and click the Show More tab underneath the video where you can view valuable links pertaining to this product, similar how-to videos, and our low-cost, no-contract alarm monitoring services.