 Okay, let's open up our tool organizer inside. We have our very easy to follow instruction booklet. The thing is simple. Any DIYer can do it. We have some hardware that comes with it with a little wrench. We have our side pieces. One's for screwdrivers and whatnot. The other one's for pliers, hammers, etc. Then we have our top piece and we have our hanger to put different things in. Now we're going to go hang it on the wall in the grudge. Okay, so we're going to hang our basket. I know about how high I want it and where it's going to be. I can't give you those measurements because your results are going to vary. Now we're going to draw our holes. Make sure that there's nothing behind this wall like a water line or electrical wires. Now we're going to tap our anchors in that are supplied with the slotted holes. You can start your screws now. Put this on then tighten them down. Again, the slotted holes make it nice and easy for installation. Now we can finish tightening the screws. I'm just using a long Phillips screwdriver. Now we're going to hang our side pieces on. This one's for the screwdrivers. It doesn't matter what side you put them on. I'm going to put it on this side because this side I'm going to utilize one of these holes to run my cords. It comes with the supplied bolts and the acorn nuts. Simply put it in the hole, put it in finger tight and you can take your little supplied wrench, hold the nut and tighten. I'm going to do the same thing with this one on the other side. Now you can organize the way you want to organize. There's plenty more room to put stuff. Very strong, easy to put up and that's rest resistant. Very handy. These you can turn either way as you can tell. As you can see I just put mine like that because I like the looks of it. Very nice unit.