Loading...

SC-3000 Cart Case Part 9 - first cast has set, open mold

2,235 views

Loading...

Loading...

Transcript

The interactive transcript could not be loaded.

Loading...

Loading...

Rating is available when the video has been rented.
This feature is not available right now. Please try again later.
Published on Aug 10, 2012

Part 9 of the great SC-3000 Survivors Cartridge Case Project. The first cast has set. Time to open the mold and see how it looks. It looks very good for a first attempt. There are some air pockets in the areas I was expecting because the ends of the sprue holes were covered with a thin layer of silicon. But overall I'm very happy. You can see all the flashing at the edge of the mold - that is expected for a plug mold like this one.

Loading...

When autoplay is enabled, a suggested video will automatically play next.

Up next


to add this to Watch Later

Add to

Loading playlists...