 Hey everyone, Drew with GeoArmin. I am back to talk to you about the GeoAlarm control panel and how to enable and disable auto-arming bypassing, which is a feature that will allow your system to actually arm even if you have a sensor faulted. This is a really easy process to do here. You just hit the hamburger icon into your master code, okay? You're gonna hit arming. And there's two modes that you can do this in for both staying and for leaving. Staying is obviously when you're home and you arm it. Leaving is for when you're leaving. We'll hit staying. That feature is located right here. It's called bypass arm. You could turn that off. If you turn that off, it won't bypass the sensors and you'll have to figure out every single fault. So if you have like a window open or something like that, the system will not allow you to arm it until you fix that. Now if you turn it back on here, then at that point, if something is opened, it will bypass it automatically so that you can arm the system. That's how you do it in stay mode. Leaving mode. Same exact thing. Right here. You just enable and disable it. Hit the back arrow to exit out of programming. And that, ladies and gentlemen, is how you enable and disable auto arming bypassing for the Geo Alarm Control Panel. If you have any questions or any comments, please leave them below. Other than that, take care and have a great day. Please like and subscribe to our page for helpful programming and installation videos, product reviews, monitoring, products, and more. Visit www.gawarm.com or call 877-443-6276. That's www.g-e-o-a-r-m.com or 877-443-6276. Geo Arm, the worldwide leader in DIY security.