 Hello, this is our XT-60 which enables the creation of contactless connectors. Thanks to 60 GHz-based RF communication, we can replace contact-based connections by wireless wires. XT-60 is perfect for industrial and wearable applications. XT-60 can support EUSB-2 protocol up to high speed at 480 Mbps, as well as ISCR-C, UART, SPI, or Dual GPIU. It gives great advantages in that we can have a fully sealed device and reliably under rotation, even at very high speed. We can also have full galvanic isolation and operation in difficult environment. For wearable, it is great due to its very small footprint because of the antenna inside the package. And its very low power capability. Let's check out the demo now. We have a USB-2 360° rotating connection. On the fixed side, a fully standard PC with its USB connector. The ST-60 evaluation board is directly plugged into it without any software modification. On top of the rotating element, we have a standard USB-2 camera which is connected to the second ST-60 evaluation board. When the two boards are flashing each other, the data link is automatically established. As we can see, the video is transmitted through the RF-Link to the PC and we can rotate the camera and the video is fluent. Typically, rotation rate of several thousand of turns per minute can be achieved and ensure lifetime of many years. Just check out the small footprint of the ST-60 A3 solution with its integrated antenna. With a size of 3 x 4 mm², the ST-60 A3 is great for many wearable equipment. ST-60 can as well be a perfect solution to securely download software and test product during the manufacturing. And thus, allow the complete removal of the Pogo connection for product configuration and testing. We can have a fully sealed and smart design together with short testing time. This also brings the capability to develop software and new application without opening the device. To conclude, to remove contact or connector on your device, ST-60 A3 provides a solution for protocol like a USB-2, UR, e-square-C, SPI or dual GPIO. And it's perfectly fitting the requirement of many wearable products. It is available for volume production with a full development kit and you can find more information on ST.com slash ST-60 or contact your usual ST representative. Thank you very much.