 Here you guys is Kevin. If you own an absent printer, sometimes you get a scanner error. It may be as easy as your lamp is burned out, or maybe something in your ADF feeder, some mechanical problems. Today, I'm going to show you how to take the scanner off, so at least you can start troubleshooting it. Or maybe you just say, well, whatever, I'm just going to buy a new unit, and you can go to bchtechnologies.com, see if we have it. And you go to printer parts, scanner parts. So you can just buy the whole unit with all the wire everything and install it. We're going to turn to the back of the printer with a Phillips screwdriver. We're going to remove with those two screws. Give a little jiggle, then you can remove this plate. You're going to unplug all those wires. It looks like a jungle, but let me explain to you. It's pretty simple. Before you start messing it, take your cell phone and take a picture of this. And if you scrub, you'll know how to fix it. There's only one wire with a yellow base. So it's a red and a black wire with yellow. Then you have a red and black with white. Easy to tell them apart. Then we have four wires. This wire doesn't go to the scanner, so just ignore it. Three wires, black, white, and green. Notice the notch on the top. So when you put it in, you insert it to the slot, just like this, and that will fit. There's only one way to put it in, so you make any mistake. So there's no way we can confuse with which wire goes to where. So we're just going to start pulling them out. There's this big thing. The FFC cables, you don't need any special tool. You just pull out like this, and then we'll insert it. And just remember the blue is towards your right, and then insert it back. You can just use your hand, insert it. You don't need the tools. Then there are two ground wires together and secured by our screw. So we just unscrew it, and you can take the wire out. And now we're ready for the next step. I usually start from the right side, and you can see here there's a tap. Let me give you a closer look. So if you use a finger, just move it to the right, and you can see the scanner is coming out. OK, I'll put my hands here and the proof. And when I lift it, I usually just close the lid. I put my hands here and close the lid. I create a lid in the front. Then this side is lifted. OK. To lift the left side, we need to unscrew this screw on the top first. The scanner is addressed on this thing that goes to the printer. Then the scanner should be slide with angle upwards like this. And so let me show you. I put my hands here, tap, close. Now lift the whole scanner off. Unit this off. To put it back, the same thing. Here's the slot that you slide this one in. So you roughly put it in the position and just try to slide it down. You don't have to be precise. Then once you close it, then pay attention if the scanner is even. If it's not even, just lift it up and push it down. Lift it up and push it down, and it's going to fall into the place. Once you can see, it can open close easily. And everything's good. Then you can put that screw back. I hope you enjoyed this video. Visit us at www.bchtechnologies.com or locally Greensboro, North Carolina. Cheers.