 Hello everybody and just welcome back to my V-LOG. Now this is just a very quick just to show you because there are no destructions for this particular setup, how this goes together. Now normally you would have a plate like this with the bolt like nuts built in. That would go on the bottom of your craft but in this instance it doesn't. So this will be the front, these legs are splayed like this and so as you can see there look they're cut in with an angle. There's an angle going on the side here as opposed to these ones which is pretty much a straight fork in there on the back. So it's got that sort of look and that's with the bottom plate there is where the camera would go right here. And then this one once you've got this little cross thing sat in the middle will go on top just like this. Now here again, well there are no bolts for your motors you'll have to get those. All these smaller ones will be for when you're setting up your standoffs and then you've got some another two sets of bolts here one's slightly larger than the other and these are going to be for if the larger ones will go on the place where your flight controller is going to be because like in my instance here let me just go to that there. I won't be putting them in that red base there that just came with the that just came with the quad frame but I will be using a separate distribution board for my ESCs as to the flight controller which is on top. So I'll have to put a standoff coming out of here and as they're 32mm I need it slightly longer here for the standoffs because the shorter ones will just fit flush. If you're using the 20mm flight controller and the ESC system then you put the slightly longer ones onto there and the shorter ones onto here. Okay I mean that that's it that's everything else is pretty much self-explanatory. The way these go is self-explanatory if I just fit this for you so you can look at the way this is supposed to fit in here and that will fit like that on both sides and hopefully you can see the shape and you see the shape of that and I'll just show that again for how it will fit on the other side. It will be that way around on the other side because at the back here is where you're going to be able to adjust the fitting for your camera when you fit it the 19mm camera. The shorter standoffs then will be on the back here and the longer standoffs sorry about my shaky hands will be on the front like so and that's how it will all fit together. So very quick very short very sweet but is it just to show you how that would be set up.