 Hey everyone, Drew with GeoArm and I am back to talk to you about the GeoAlarm GeoCP control panel and how to enable and disable the countdown beeps. If you're like me, sometimes you get a little tired of hearing those audible countdowns. So what you can do is you can actually disable them so that your panel is silent. We're going to go ahead and enter the hamburger icon there. Put in your master passcode, mine is 1234, but yours will probably be changed to something else. You're going to go into harming. Now this is dependent upon which mode. So we'll go ahead and we'll start with staying. If you don't want that audible countdown, you can go ahead and disable that there by just pressing the little slide icon. The beep is now disabled. Also the voice enunciation is there. That's audible as well. So you may, if you're not wanting to hear anything, want that disabled too. I'm going to go ahead and turn both of mine back on. But that is how you do it for staying. Now we'll do the same for leaving. There it is for leaving. Go ahead and press the little slide. Same thing for voice. And now we're silent as of right now. So I'll go ahead and now re-enable those because I don't want to disable them. Press the back arrow, back arrow, back arrow, get out of programming. And that, ladies and gentlemen, is how you can enable and disable the audible tones when you're arming. Any questions or comments, please leave them below. Other than that, you take care and stay safe. Please like and subscribe to our page for helpful programming and installation videos, product reviews, monitoring, products, and more. Visit www.gorm.com or call 877-443-6276. GeoArm, the worldwide leader in DIY security.