Loading...

I CHANGED THE GAS CONTROL VALVE- photos&short video

19,509 views

Loading...

Loading...

Transcript

The interactive transcript could not be loaded.

Loading...

Loading...

Rating is available when the video has been rented.
This feature is not available right now. Please try again later.
Published on Nov 30, 2011

my first time changing a gas hot water heater gas control valve.
.tools two pipe wrenches&three -four smaller wrenches
pluming tape pipe dope.
step 1.cut off gas&water to hot water heater.
step 2.disconnect gas line to the unit then disconnect all the parts between the gas control valve& the burner tray below&ignition switch
step3. !!!!!rember make sure you drain the heater tank of water!!!!!!
step 4. connect the new unit to the tank& check gas line for leaks after you connect the gas line with plumbing tape&pipe dope then try and ignite the heater after to refill the tank with water..
step 5. once your heater is running do a final check to see if all is running well

  • Category

  • License

    • Standard YouTube License

Loading...

When autoplay is enabled, a suggested video will automatically play next.

Up next


to add this to Watch Later

Add to

Loading playlists...