Upload

Loading...

Utilization of Radiant Energy 1901 Nikola Tesla,my setup 1

15,548

Loading...

Loading...

Transcript

The interactive transcript could not be loaded.

Loading...

Loading...

Rating is available when the video has been rented.
This feature is not available right now. Please try again later.
Uploaded on Feb 27, 2008

In this video I show you how to make the insulated plates that I use in the attic. This also gives you a better view than the one in the attic which is hard to see because there wasnt alot of light. I take plastic laminant and stick it to the HVAC metal and do this to both sides giving a fully insulated plate. After it is sealed, I drill a small hole in the corner and put a bolt and nut on the end which I will use to attach the wire for the antenna or to the other plates via a wire.

Remember that the metal plates are out of the sun and function day and night. Though results might change when its outside, the plate charges without direct sun during the day and without the sun at night, showing other particles hitting the plate.

PLEASE LEAVE A COMMENT AND TRY THIS OUT FOR YOURSELF, IN ANOTHER VIDEO I SHOW THE RESULTS. THIS NEW PANEL WILL TEST IF A THIRD PANEL HELPS CHARGE THE CAPACITORS FASTER AND WITH A HIGHER VOLTAGE. THE AMOUNT OF ENERGY IS PROPORTIONAL TO THE AREA OF THE PLATES STATED IN THE PATENT. I WILL TEST THIS OVER THE WEEK AND GIVE RESULTS. CHECK BACK IF YOUR INTERESTED!!

Loading...

When autoplay is enabled, a suggested video will automatically play next.

Up next


to add this to Watch Later

Add to

Loading playlists...