 Hey guys, Drew with GeoArm and I'm back with the 2GIG Edge system, the brand new 2GIG Edge system and we are going to be deleting a sensor which is super, super easy. This panel is amazing and super friendly to work with. So we're going to go ahead and hit the gear in the bottom right, you're going to enter your installer code 1561 and that should get you in. At that point scroll down to the very bottom and you're going to click on installer toolbox. Once you've clicked on installer toolbox, you'll see a new set of options appear. Go ahead and hit panel programming. Once you have hit panel programming, go ahead and go into wireless zones. Once in wireless zones, you find the zone that you want to delete. So in this case the only one that I have programmed currently is zone one which is a door window contact. I'm going to go ahead and get that out of here and the way that you do that is you just look in the bottom left hand corner, there's a red button that says reset zone. Go ahead and hit that. It'll ask you to confirm. Go ahead and hit reset at that point. And at that point you should be ready to go ahead and get anything new programmed in that you need to or just leave it the way it is. But there is no zone there any longer. After you have hit that reset zone and confirmed it, it is deleted out. So at that point, you go ahead and exit out of programming by hitting the back arrow up in the top right hand corner until you are completely out of programming. That is how you delete a zone on the 2GIG edge system. Make sure to subscribe to our YouTube page and click the show more tab underneath the video where you can view valuable links pertaining to this product, similar how-to videos, and our low-cost no-contract alarm monitoring services.