 Hey everyone, Drew with GeoArm and I am back to talk to you about the transmission delay and how to increase and decrease it on the GeoAlarm control panel. If you're not familiar with what a transmission delay is, what that is is an additional time that it's going to wait before it actually transmits that alarm over to Central Station. It's easy to configure. A lot of people like to have that option because sometimes mistakes are made. So say you walk in through your front door, you wait a little longer than that delay time that's normally set, and then it catches you. What this feature will do, transmission delay, is it'll wait an additional amount of time beyond that until it sends a signal. So you can disarm the system without getting bothered by the Central Station. So what you're going to do, you just go ahead and hit that hamburger icon. And to your master passcode, minus one, two, three, four, you would have configured yours at the initial setup, or changed it. Go ahead and enter security, and the transmission delay is right here. I typically like to set my systems up with no transmission delay because I want that signal to go right away. But inherently, from factory, it will be 30 seconds. If you guys have any questions on how to set that or any comments, please leave them below. Go ahead and exit out of programming there. That is how you set the transmission delay on the GeoAlarm control panel. You guys take care and stay safe. Please like and subscribe to our page for helpful programming and installation videos, product reviews, monitoring, products, and more. Visit www.geoarm.com or call 877-443-6276, that's www.geoarm.com or 877-443-6276, Geoarm, the worldwide leader in DIY security.