 Hey, what's up guys? Joe Holland here. I'm gonna show you a 10-inch hole with a Milwaukee hand drill Let's go is the G2 By Ion lower made for their G2 auger But if you already have a hand drill you could buy the lower on a sewn and as you can see She rips she cuts pretty fast. I have no sponsorship with either one of these companies I'm just always after the biggest hole Quickest hole lightest unit, and I'm pretty sure I found it right there with the Ion G2 and The Milwaukee. I guess you could use a DeWalt or any hand drill that rips Let's see how much This is backwards 15 to 27 12 inches that was 12 inches of ice Pretty good rip on 12 inches ice. I Think I have the weapon of choice now I think that bigger is always better Bigger is always better for holes when you're ice fishing For a couple reasons one. It's easier to land the fish. You figure almost You figure probably 90% of your lost fish happen in the hole or around the hole as you're trying to get that things Head started so the bigger the hole the higher your chances are of landing that fish And then the other thing is for freeze up So it's like super cold out an 8-inch hole or a 6-inch hole freezes A lot quicker than a 10-inch hole will The beauty about not being sponsored is I don't care what you use I'm just sharing what I'm using with people because a lot of people ask and I'm always after the lightest auger and I'm always after the biggest hole and the quickest to that one weighs Five pounds that lower So that's pretty light and to put it on a drill. Do you get it together? All right, so the this is the pistol bit laser, which is also Well, that's nice if you're not rechecking all right, so you just chuck this into your drill and you're done Right, that's a problem. I had my K drill is it fall off. Yeah Are you able to see the drill close them up?