How To Install Replace Part 2 Front Lower Ball Joint Chevy GMC S-10 S15 1AAuto.com





The interactive transcript could not be loaded.



Rating is available when the video has been rented.
This feature is not available right now. Please try again later.
Published on May 4, 2010


1A Auto shows you how to install a front lower ball joint on a 2002 Chevy S10 Pickup Truck 4x4. This is the same procedure on any 98, 99, 00, 01, 02, 03, 04, 05, 06, 07, and 08 Chevy S-10 Blazer, 98 to 04 S-10 Pickup Truck, GMC Jimmy or S15 Sonoma. You can diagnose a faulty ball joint by raising the front tire off the ground while supporting the control arm. Then use a pry bar or 2x4 under the tire. Have a person move the tire up and down with the pry bar while you look at the ball joint for side to side motion.

🔧 Instructions:

1. Clean up the top of the upper control arm 1:00
2. Install the ball joint 1:07
3. Install the tie rod. 2:18
4. Install the hub 3:35
5. Install the brakes 6:05
6. Install the hub nut and wheel. 7:00

While 1A Auto strives to make the information provided in this video as accurate as possible, it makes no claims, promises, or guarantees about the accuracy, completeness or applicability of the content. No information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. All do-it-yourself projects entail some risk. It is the sole responsibility of the viewer to assume this risk. 1A Auto is not responsible or liable for any loss damage (including, but not limited to, actual, consequential, or punitive), liability, claim, or any other injury or cause related to or resulting from any information posted in this video.



to add this to Watch Later

Add to

Loading playlists...