Loading...

PRIMACY - How to activate the flip-over module

11,030 views

Loading...

Loading...

Transcript

The interactive transcript could not be loaded.

Loading...

Loading...

Rating is available when the video has been rented.
This feature is not available right now. Please try again later.
Published on May 15, 2012

http://www.evolis.com/drivers-support...
Your printer is a single-sided printer and you wish to activate it in two-sided mode.
To do this, obtain the activation key for the flip-over module.

Carry out the following procedure to activate your printer in two-sided mode:
Your printer must be powered on and active (not in standby mode).

- Open the printer cover.
- Remove the ribbon from the printer if present.
- Take your activation key and insert it in the location provided.
- Close the cover. The 3 LEDs on the control panel start flashing one after the other for between 5 and 10 seconds.
- Activation has finished and is successful when the 3 LEDs remain lit for several seconds then turn off.
- Open the printer cover and remove the activation key. Put the ribbon back.
- Close the cover.

Carry out a print of a technical test card to obtain all the updated information about your printer after activation has taken place.
Follow the procedure below:
- Ensure a card is present in the printer.
- Press the pushbutton for four to five seconds until it turns off.
- Press and hold down the pushbutton again. The indicator light on the pushbutton comes on.
- Release the pushbutton once the indicator light flashes.
- The test card is printed.
- The printed card is ejected into the output hopper. To remove it, open the door of the output hopper.

The printer is ready for two-sided printing.

Loading...

When autoplay is enabled, a suggested video will automatically play next.

Up next


to add this to Watch Later

Add to

Loading playlists...