Loading...

Bob Smith Industires Insta-Set Accelerator and UN-CURE by ModelMerchants.com

3,360 views

Loading...

Loading...

Transcript

The interactive transcript could not be loaded.

Loading...

Rating is available when the video has been rented.
This feature is not available right now. Please try again later.
Published on Aug 17, 2015

We explain how to properly use Bob Smith Industries' Insta-Set Accelerator (BSI151/BSI152) when using it with Cyanoacrylate CA glue and removing any accidental/excess applications of CA glue by using UN-CURE (BSI161), a Cyanoacrylate debonder.

Visit us online at http://www.modelmerchants.com

Buy INSTA-SET Accelerator: https://modelmerchants.com/shop/bob-s...
Buy Bob Smith UN-CURE: https://modelmerchants.com/shop/bob-s...

Please leave your questions/comments in the comment section below and thanks for watching.

Bob Smith Industries Insta-Set Accelerator (BSI151/152): INSTA-SET™ is a catalyst which acts as an accelerator that allows CAs to quickly cure in thick layers by enhancing the alkaline conditions during polymerization. INSTA-SET™ in a spray bottle is normally used to cure the CA that flows from joints when parts are pressed together. Applying an additional bead of thick CA along a seam and then curing it with INSTA-SET™ significantly enhances a joint’s strength. For difficult to bond materials, INSTA-SET™ can be applied to one surface and CA to the opposite surface. When brought together, they will bond instantly. INSTA-SET™ is formulated with a strawberry scent and activates CA in 6 to 8 seconds without any degrading of the CAs strength, which can occur with many other accelerators. It is compatible with all surfaces, even clear plastic and white foam.

Bob Smith Industries UN-CURE: UN-CURE™ debonder will soften cured CA. If parts are bonded incorrectly or your fingers are stuck together, a few drops of UN-CURE™ will dissolve the CA in about a minute. Apply on bonded skin and roll apart fingers. Once stuck, use acetone to clean off softened CA, then wash off with soap and water. Since cured CA is essentially acrylic plastic, anything that will dissolve CA will also soften most plastics. Care must be used, therefore, when using Un-Cure on plastics. Separating plastics parts with a razor saw is usually the best option.

Loading...

When autoplay is enabled, a suggested video will automatically play next.

Up next


to add this to Watch Later

Add to

Loading playlists...