 Welcome to the SNAP. This is a segment where we answer frequently asked questions in a very rapid fire format. So let's get right into it. On today's episode of the SNAP, I'm going to be demonstrating to you how to properly clean your M-plus vaporizer. Now this will be applicable whether you just received your new M-plus or if you've been using it a while and it's a little bit dirty. To clean your M-plus, you will need the obvious M-plus, a watertight container. I'm using a storage tube, but you could also use a Ziploc bag, a pipe cleaner, a cotton swab, or maybe a couple cotton swabs, and cleaning solution. In this case, I will be using isopropyl alcohol. To start cleaning your M-plus, you need to take your M-plus, set your cap aside. Now if I was doing a quick and dirty cleaning, I could take this whole device, the condenser, o-rings, tip and all, without disassembling, throw it into my watertight container and I would be good to go to start the rest of the cleaning process. But because this is the first time I am cleaning it, I want to fully disassemble so I can get into all the nooks and crannies, set the cap aside. Do not soak your cap in cleaning solution. Now I will take the parts, I will start, put the condenser in there, I'll put the stem, and then I'll put the tip inside and then I will add my desired cleaning solution. The reason why I put the device in first is it prevents excess waste because I will only need to put in what I want and what I need. At this point, we'll want to give it a good shake. Several long excruciating minutes later. Now that we've let the M-plus soak for a little while, now we can empty it out and give it a good scrub. Lay down my cloth, in this case I'm using a paper towel, open up my storage container and dump everything out. Make sure that everything is apart. I'm going to take my pipe cleaner and give the condenser a good scrubbing. Also going to do this with the tip. Both sides just kind of get any of that really gunked on particulate. Do the stem. For good measure, I will use a cotton swab and get into all those nooks and crannies, including the square port, the tip, the bowl, and then the condenser. Then wash your VapCap off in the sink, let it dry, and reassemble. Insert the condenser into the mouthpiece end of the stem. Seat the larger O-ring until it is flush. We recommend using DynaWax to lubricate the tip O-rings during the assembly. Now that your stem and condenser is together, insert the tip into the stem by twisting the tip. Finally, place the cap back on the tip. In conclusion, we just showed you how to clean your M Plus. Be it brand new, be it really dirty, but now you are all set. And so now go dirty it up again. Thank you for watching The Snap. I'm Retail Josh, and thanks for watching. you