How to Program an RCA Universal Remote Control





The interactive transcript could not be loaded.



Rating is available when the video has been rented.
This feature is not available right now. Please try again later.
Published on Aug 23, 2010

Watch more How to Buy & Set Up a TV videos: http://www.howcast.com/videos/383468-...

Program your RCA remote to work with your TV without code search instructions.

Step 1: Find TV button
Find the TV device button near the top of your remote, usually in the top right corner.

To program other devices, follow these steps using the Other Device buttons on the remote.

Step 2: Find the on-off button
Find the power button near the top of the remote, usually located in the middle at the top.

Step 3: Press and hold buttons
Press and hold the TV button; the TV button will illuminate. Then press and hold the power button at the same time.

Step 4: Release the buttons
Release both buttons once the remote buttons below blink. The TV button should now stay illuminated.

If the TV button does not stay illuminated, repeat the process making sure to hold the buttons down a little longer after you see the other buttons blink.

Step 5: Press and hold play
Point the remote at your TV with the TV turned off. Press and hold the play button at the bottom of the remote.

Step 6: Hold the play button
Hold the play button down until the TV turns on. You'll see the TV button blink as it transmits codes to the TV.

Did You Know?
Remote-controlled model airplanes were available to the public in 1931.


When autoplay is enabled, a suggested video will automatically play next.

Up next

to add this to Watch Later

Add to

Loading playlists...