Loading...

SC-3000 Cart Case 13 - 3D logo mold and casting test

1,717 views

Loading...

Loading...

Transcript

The interactive transcript could not be loaded.

Loading...

Loading...

Rating is available when the video has been rented.
This feature is not available right now. Please try again later.
Published on Sep 17, 2012

Results of the test mold and cast on the 3D printed SC-3000 Survivors logos. They trapped a few air bubbles in the lettering, but nothing too bad. I think they will look good. So now I am free to make up the final mold for the bottom half of the cart case including a nice little SC-3000 Survivors logo. Woohoo!

Loading...

When autoplay is enabled, a suggested video will automatically play next.

Up next


to add this to Watch Later

Add to

Loading playlists...