 Alright everyone, we're going to show you how to install the GeoGBD in this video. It's very easy. What we're doing here first is we've already pre-measured the holes there that we're going to need to put the anchors in. So he's going ahead right now and he's just pre-setting the hole so that it can fit the anchor. You usually want to do that with the tip of a screwdriver, a Phillips head specifically just to make the hole a little small and then increase the size as needed. As you can see here he's putting the anchors in place, making sure the hole is one final time the right size and he's putting those in place. Sometimes it does require a little bit of assistance to get into the hole like that. That's good. That means that it's going to hold up and catch. So what we're going to do now is we're going to go ahead and put the back plate in place. As you can see here he's mounting the back plate by putting in the two screws directly into the anchors that were placed in the wall. Once you have tightened it in place and got everything the way that it needs to be in terms of tightness, don't over tighten because then you may mess it up for the future in terms of trying to take it off. But grab the device, place it in there and then all you're going to do is turn it clockwise once you have it in the right grooves there. Once you've done that your glass break detector has been installed. Please like and subscribe to our page for helpful programming and installation videos, product reviews, monitoring, products, and more. Visit www.goarm.com or call 877-443-6276. That's www.geoarm.com or 877-443-6276. Goarm, the worldwide leader in DIY security.